Stacked Chaise Lounge Covers: Measure Nested Decks, Stack Height, Backrests, and Wheels

Stacking chaise lounges saves deck space, but the stored bundle is taller, longer, and more stepped than one chair. A custom stacked chaise lounge cover should follow the stable storage stack, not the dimensions of a single lounger multiplied by the chair count.

Clean and dry every frame before stacking. Remove cushions unless the furniture manufacturer approves covered outdoor storage. Lock adjustable backs in one repeatable position, align wheels and legs, and confirm that the stack is stable before measuring or installing a cover.

Define the Exact Stack

Record the chair model, quantity, stacking order, and orientation. Similar loungers can nest at different depths when arm styles, wheels, or replacement feet vary. Mark the bottom chair and the highest back so the same configuration can be rebuilt after cleaning or seasonal use.

Measure the Maximum Stored Envelope

Use How to Measure to capture total length, maximum width, and overall height at the highest back. Measure width at several points because arms, wheels, and rear frames may project differently. Submit the largest fixed dimension, not an average taken across the bundle.

Map the Stepped Foot End

Nested seats often create a staircase of deck ends, rails, or feet. Measure the horizontal run and vertical rise of each important step, then photograph the profile from the side. A shaped front panel can reduce loose fabric without pressing against sharp chair ends.

Record Backrest Angles and Stack Growth

Set every adjustable back to the approved storage position and measure the resulting slope. Note how much each added chair increases height and rear depth. Do not assume the backs are parallel if hinges or stops have different wear positions.

Include Wheels, Axles, and Transport Handles

Measure wheel diameter, axle projection, handles, and any pull bar that stays attached. Identify which side needs easier access when the stack is moved. Keep closures clear of rolling surfaces so straps cannot catch under a wheel during repositioning.

Protect Contact Points Between Chairs

Inspect where frames nest and add pads recommended for the furniture finish when needed. A cover cannot correct an unstable stack or stop metal-on-metal rubbing inside it. Smooth or guard exposed bolt ends before they become concentrated pressure points against the outer fabric.

Choose Fabric for a Large Movable Bundle

Review flexible, abrasion-resistant options at Our Fabrics. The fabric should be manageable by the people who normally uncover the stack. Reinforcement is most useful at high back corners, layered foot ends, wheel housings, and repeatable frame contacts rather than across every panel.

Support Drainage and Air Exchange

Park the stack on a drained surface with the hem above puddles and pool splash. Dry frames and sling fabric before covering. Covered vents may support passive air exchange, but they do not make it safe to trap wet towels, cushions, or chlorinated water inside a dense stack.

Anchor Without Collapsing the Nest

Place straps around stable lower frames or designated rails on the bottom chair. Avoid pulling the top chairs sideways or compressing adjustable mechanisms. If the manufacturer requires wheel locks or floor anchoring, complete those steps before relying on a cover for wind management.

Prepare a Repeatable Stacking Brief

Send the chair count, stacking sequence, maximum dimensions, stepped front profile, back slope, wheel and handle locations, reinforcement zones, hem clearance, and anchor points. Visit the Stacked Chaise Lounge Cover page, compare Patio Furniture Covers, and request a quote for an unusual nest.

Frequently Asked Questions

Should I measure one chaise or the complete stack?

Measure the complete, stable stack in the exact storage position that will be covered.

Can cushions remain in the stack?

Remove them unless their care instructions and the furniture maker specifically allow covered outdoor storage.

Can the covered stack be rolled?

Plan to remove or fully secure the cover first, and keep all straps away from wheels and the travel path.

Turn the Measurements Into a Production-Ready Cover

A reliable stacked-chaise brief is based on one repeatable bundle: fixed chair count, fixed back angle, aligned wheels, and documented steps. Measuring that stored shape directly produces a cleaner fit and safer handling than scaling up the dimensions of one lounge chair.