Double Porch Swing Covers: Fit Twin Seats, Shared Stands, Beams, and Feet

A double swing system combines two moving seats with one wide structural stand, so its protected envelope changes when either seat drifts. A custom double porch swing with stand cover should be measured around one repeatable parked position rather than an average of the furniture in motion.

Place the stand on level ground, stop both swings, remove loose accessories, and follow the furniture maker’s locking or storage instructions. Never use the cover or its closures to restrain damaged chains, unstable feet, or a frame that is not properly anchored.

Define the Exact Parked Position

Label the left and right seats and center each one as the maker directs. Record seat angle, distance from the rear legs, and any approved tie or latch used during storage. Photograph the full system from front, side, and above before moving anything.

Measure the Shared Stand Envelope

Follow How to Measure to capture maximum width, depth, and height across the outer feet, side frames, and top beam. Check widths at the floor, seat rails, suspension points, and ridge because an A-frame narrows as it rises.

Survey Both Swing Seats Separately

Measure each seat’s back height, seat width, arm projection, cushion thickness, canopy hardware, and lowest edge. Do not assume the seats are identical. Replacement cushions or one repaired frame can create a different bulge beneath the finished cover.

Map Suspension Hardware and Motion Gaps

Locate chains, springs, hooks, bearings, and crossbars, then record the safe clearance around each. Measure the gap between seats and the nearest frame members. Fabric should not be pinched into a suspension point or asked to stop the swing’s movement.

Record Feet, Braces, and Ground Contact

Number all feet and measure their outside footprint, splay, base plates, and cross braces. Note anchor bolts, rockers, leveling pads, or projecting fasteners. Choose a hem plane that stays clear of wet decking and does not rub against sharp hardware.

Decide Which Cushions Stay Installed

List every seat pad, back cushion, headrest, and canopy panel that remains. Dry and arrange them consistently before measuring. If soft goods are stored indoors, create the entire brief around the bare frame and repeat that configuration each time.

Shape the Ridge and Side Panels

The top beam may need a reinforced ridge while the broad front and rear faces need controlled ease over two seat backs. Mark the tallest hard points and identify unsupported valleys between seats. A stable spacer may be used only if the furniture maker allows it.

Select Fabric and Secure Closures

Compare weather performance, abrasion resistance, flexibility, cleaning, and finished weight on Our Fabrics. Explore Patio Furniture Covers. Place closures at stable lower rails or feet, away from chains, springs, moving joints, and walking paths.

Build a Two-Person Covering Routine

Orient the ridge mark over the center beam, lower the cover across both ends evenly, and guide fabric around the parked seats without pulling on suspension hardware. Secure opposite corners gradually. Remove the cover completely before anyone sits, swings, or adjusts the frame.

Prepare the Double-Swing Brief

Send parked-position photos, stand envelope, individual seat dimensions, suspension map, motion gaps, cushions, feet, anchors, ridge, hem clearance, exposure, and installation route. Review the Double Porch Swing With Stand Cover page.

Frequently Asked Questions

Can one cover hold both swings still?

No. Park or lock the seats according to the manufacturer; the cover is not a structural restraint.

Should I measure the seats while they hang at different angles?

No. Establish one repeatable safe storage position and measure both seats in that configuration.

Can cushions remain on the swings?

Yes only when dry, securely positioned, approved for outdoor storage, and included in every dimension.

Turn the Measurements Into a Production-Ready Brief

A double swing becomes one coverable object only after both moving seats are parked consistently inside a verified stand envelope. Combining the ridge, suspension zones, individual seat profiles, outer feet, and safe lower anchors helps CoversForge evaluate a cover that installs predictably without serving as a brake or brace. Request a Quote when the measurements and photographs are ready.